Slip Testing for Builders & Construction
Verify your new floor installations meet P-rating requirements before handover. Independent slip resistance testing to AS 4586:2013 for new pedestrian surfaces.
Get It Right Before Handover
New floor installations must meet specific P-rating requirements under the Building Code of Australia. Discovering non-compliance after handover means costly rectification, delays, and potential disputes with your client.
The Problem
Tile and flooring specifications do not always match installed performance. Adhesive, grout, installation methods, and even batch variations can affect the slip resistance of finished surfaces compared to manufacturer data sheets.
The Consequence
Non-compliant floors discovered post-handover lead to defect claims, costly remediation work, project delays, and potential disputes with building surveyors, clients, and certifiers. Your professional reputation is on the line.
The Solution
Independent pre-handover slip testing by Greg Collins verifies that your installed surfaces meet the required P-ratings. Catch and address any issues before they become defect claims.
Builders and construction companies across Melbourne rely on Surface Test Australia for independent verification of new floor installations. Whether you are completing a residential apartment development, a commercial fit-out, or a public amenity, Greg provides the on-site testing that confirms your flooring meets the slip resistance requirements specified in the Building Code of Australia and referenced through AS 4586:2013.
The NCC (National Construction Code) specifies minimum P-rating requirements for different areas within buildings. Wet areas such as bathrooms and pool surrounds typically require P4 or P5, while general pedestrian areas need at least P3. Ramps and external areas have their own requirements. Relying solely on manufacturer data sheets is risky because the installed performance of a surface can differ from laboratory test results due to installation variables, grout profiles, and surface treatments applied on site.
Greg's pre-handover testing provides independent, on-site verification using calibrated wet pendulum testing equipment. The results are documented in a comprehensive report that can be included in your handover documentation, presented to building surveyors, and retained as evidence of compliance. If a surface does not meet the required P-rating, Greg identifies the issue early so you can address it before practical completion, avoiding costly post-handover defect claims.
Surfaces We Test for Builders
Greg tests new installations across all building types to verify P-rating compliance before handover.
Bathroom & Ensuite Tiles
Wet area surfaces requiring P4 or higher for NCC compliance
Lobby & Common Area Flooring
New tiles and finishes in high-traffic pedestrian zones
External Paving & Ramps
Outdoor surfaces exposed to weather requiring specific R-ratings
Pool Surrounds & Wet Areas
Constantly wet surfaces demanding the highest slip resistance
Commercial Kitchen Floors
Specialist flooring requiring P4/P5 for grease and water exposure
Car Park Surfaces & Ramps
Vehicle and pedestrian areas with specific gradient requirements
Your Compliance Obligations
AS 4586:2013 — Classification of slip resistance for new pedestrian surface materials. This standard defines the P-rating system that the NCC references for new installations.
National Construction Code (NCC) — Specifies minimum P-rating requirements for different areas and uses within buildings. Compliance is verified at handover.
Building Surveyor Requirements — Building surveyors may require independent slip test reports as part of occupancy permit documentation. Greg's reports satisfy these requirements.
Defect Liability Period — Pre-handover testing provides documented evidence that surfaces were compliant at practical completion, protecting you during the defect liability period.
How We Help
Schedule Pre-Handover
Call or SMS Greg once flooring is installed and grouted. He can attend site at short notice to meet your project timeline.
On-Site Testing
Greg tests all nominated surfaces on-site using calibrated wet pendulum equipment to determine actual installed P-ratings.
Handover-Ready Report
Receive a comprehensive report with P-ratings for each surface, suitable for building surveyors, certifiers, and handover documentation.
Our Services
Learn more about the specific tests and reports Greg provides for builders and construction companies.
Need Pre-Handover Slip Testing?
Call or SMS Greg today for a free, no-obligation quote. Fast turnaround to meet your construction timeline across Melbourne and Greater Victoria.
Available Monday to Saturday across Melbourne & Greater Victoria